 | |
Supported network interfaces |
 | Ethernet 10Base-T and 10Base-FL
Fast Ethernet 100Base-T (RJ-45 and MII)
Synchronous serial
Channelized T1/E1 ISDN PRI
Channelized T3/E3
Serial (T1, E1, T3, E3)
ISDN BRI ATM enhanced (T3/E3, OC3, STM1)
ATM-CES
POS OC3/STM1
Voice-over-IP gateway to PSTN |
| |
Power supply options |
| AC, DC48V, DC24V and Dual DC48V |
| |
Port adapter slots |
| 1 |
| |
Onboard Ethernet ports |
| Two 10/100/1000 ports (two RJ45 or two GBIC interfaces) |
| |
Network processing engine |
| Based on NSE-1 fixed configuration (375 MHz RM7K with PXF processor) |
| |
PCMCIA Flash memory card (one slot) |
| 64 MB, 128 MB |
| |
Standard components |
| Front-to-back airflow
One rack unit
Single-side access
Dry relay alarm contact |
| |
AC-input power |
| 75 VA max. (single supply configuration available only) |
| |
AC-input voltage rating |
| 100-240 VAC wide input with power factor correction |
| |
AC-input current rating |
| Rated for 2A. Not to exceed 1.0A max. at 100 VAC and 0.5A max. at 240 VAC |
| |
AC-input frequency rating |
| 50-60 Hz |
| |
AC-input cable |
| 18 AWG 3-wire cable, with 3-lead IEC-320 receptacle on the power supply end, and a country-dependent plug on the power source end |
| |
DC-input power |
| 75 VA max. (single or dual power supply configuration) |
| |
DC-input voltage rating |
| -48 VDC nominal in North America, -60 VDC nominal in the European Community
Maximum range is -40.5 to 72 VDC (75 VDC for 5 mS).
Or, with optional 24 VDC power supply; +24 VDC nominal.
Maximum range +20 to +36 VDC. |
| |
DC-input current rating |
| Rated for 3A
Not to exceed 1.6A max. at -48 VDC
Not to exceed 2.0A max. at -40.5 VDC (50VA/-54 VDC = 1.0A typical draw)
With redundant power supply, individual line currents are added to give the above numbers
+24 VDC input current is 3.0A at +24 VDC, 3.75A at +20 VDC (50VA/28VDC = 1.8A typical draw)
Rated for 5A |
| |
DC-input cable |
| 18 AWG recommended minimum, with at least 3 conductors rated for at least 140°F (60°C) |
| |
Airflow |
| ~80 cfm |
| |
Power dissipation |
| 75 W max. configuration |
| |
Heat dissipation |
| 50W (170 BTU) Typical, 255 BTU maximum |
| |
Operating temperature |
| 32 to 104°F (0 to 40°C) |
| |
Storage temperature |
| -4 to 149°F (-20 to 65°C) |
| |
Humidity |
| 10 to 90% noncondensing |
| |
Dimensions (H x W x D) |
| 1.72 x 17.3 x 11.80 in. (4.37 x 43.9 x 30 cm) |
| |
Weight |
| Chassis fully configured with a port adapter ~ 10.5 lb (4.76 kg) |
| |
Regulatory Compliance |
| Products bear CE marking indicating compliance with the 99/5/EC directive, which includes the following safety and EMC standards |
| |
Safety |
| UL 1950, CSA-C22.2 No. 950, EN 60950, IEC 60950, TS 001, AS/NZS 3260, IEC60825,EN460825, 21CFR1040 |
| |
EMC |
| FCC Part 15 (CFR 47) Class A, ICES-003 Class A, EN55022 Class A, CISPR22 Class A, AS/NZS 3548 Class A, and VCCI Class A EN55024, ETS300 386-2, EN50082-1 |
| |
NEBS |
| GR-1089-Core NEBS Level 3 Requirements, GR-63-Core NEBS Level 3 Requirements |
| |
